Workshop Facilities: Steel and Diesel Engines

With a covered workshop area of 1493m2, a  hard stand area of 1300m2 , 2 x 3.0 ton, and 5.0 ton overhead cranes, no job is too big or small.

 

Fabrication: carbon steel, Stainless & Alloy

  • Specialised Welding machines to ensure all welds are able to complete to required standards and procedures.
  • Certified plate held in stock.

 

Diesel Engine

  • Diesel Engine Overhauling
  • Top end engine / vlave grinding capabilities
  • Injection pumps and valves overhauling & testing

Machine Shop

  • Universal Mill
  • Conventional Mill
  • Fitted with compound slides for both short and long tappers.
  • Able to cut all pitches of thread.
  • Can accommodate up to 4.0m shaft length at 100mm diameter.
  • Vertical Lathe with 1200mm table and a 600mm Gap
  • Radial Drill – 70mm